Memory BAT mapping: BAT2=256Mb, BAT3=256Mb, residual: 0Mb Total memory = 512MB; using 1024kB for hash table (at c0300000) Linux version 2.4.20-ben1 (scara@sherbert) (gcc version 3.2.3 20030316 (Debian prerelease)) #8 Fri Mar 28 14:23:19 GMT 2003 Found Uninorth memory controller & host bridge, revision: 17 Mapped at 0xfdef1000 Found a Keylargo mac-io controller, rev: 3, mapped at 0xfde71000 Processor NAP mode on idle enabled. PowerMac motherboard: PowerBook Titanium IV CPU MSCCR0 : 0x00008003 CPU HID1 : 0x80016c80 Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->1 hose pci, pci_mem_offset: 00000000, start0: f1000000 io_base_virt: fd66e000, io_base_phys: f0000000, isa_mem_base: 00000000 Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->1 hose pci, pci_mem_offset: 00000000, start0: f3000000 io_base_virt: fce6c000, io_base_phys: f2000000, isa_mem_base: 00000000 Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->1 hose pci, pci_mem_offset: 00000000, start0: f5000000 io_base_virt: fc66a000, io_base_phys: f4000000, isa_mem_base: 00000000 PMU driver 2 initialized for Core99, firmware: 0c On node 0 totalpages: 131072 zone(0): 131072 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/hda10 ro PowerMac using OpenPIC irq controller OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc623000 OpenPIC timer frequency is 4.166666 MHz GMT Delta read from XPRAM: 0 minutes, DST: off time_init: decrementer frequency = 33.331668 MHz Console: colour dummy device 80x25 Calibrating delay loop... 665.19 BogoMIPS Memory: 514432k available (1596k kernel code, 892k data, 128k init, 0k highmem) AGP special page: 0xdffff000 Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount-cache hash table entries: 8192 (order: 4, 65536 bytes) Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) POSIX conformance testing by UNIFIX PCI: Probing PCI hardware Scanning bus 00 Found 00:58 [106b/002d] 000600 00 Found 00:80 [1002/4c66] 000300 00 Fixup res 1 (101) of dev 00:10.0: 400 -> 802400 Fixups for bus 00 Bus scan for 00 returning with max=00 Scanning bus 10 Found 10:58 [106b/002e] 000600 00 Found 10:b8 [106b/0022] 00ff00 00 Found 10:c0 [106b/0019] 000c03 00 Found 10:c8 [106b/0019] 000c03 00 Found 10:d0 [104c/ac50] 000607 02 Fixups for bus 10 Scanning behind PCI bridge 10:1a.0, config 010100, pass 0 Scanning behind PCI bridge 10:1a.0, config 010100, pass 1 Bus scan for 10 returning with max=14 Scanning bus 24 Found 24:58 [106b/002f] 000600 00 Found 24:70 [11c1/5811] 000c00 00 Found 24:78 [106b/0021] 000200 00 Fixups for bus 24 Bus scan for 24 returning with max=24 Can't get bus-range for /pci@f2000000/cardbus@1a PCI->OF bus map: 0 -> 0 16 -> 0 36 -> 0 PCI:00:10.0: Resource 0: b8000000-bfffffff (f=1208), vd: 1002, dev: 4c66 PCI:00:10.0: Resource 2: b0000000-b000ffff (f=200), vd: 1002, dev: 4c66 PCI:10:17.0: Resource 0: 80000000-8007ffff (f=200), vd: 106b, dev: 0022 PCI:10:1a.0: Resource 0: a0000000-a0000fff (f=200), vd: 104c, dev: ac50 PCI:24:0f.0: Resource 0: f5200000-f53fffff (f=200), vd: 106b, dev: 0021 PCI:00:10.0: Resource 1: 00802400-008024ff (f=101), vd: 1002, dev: 4c66 PCI:10:18.0: Resource 0: a0002000-a0002fff (f=200), vd: 106b, dev: 0019 PCI:10:19.0: Resource 0: a0001000-a0001fff (f=200), vd: 106b, dev: 0019 PCI:24:0e.0: Resource 0: f5000000-f5000fff (f=200), vd: 11c1, dev: 5811 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Thermal assist unit not available HID1, before: 80016c80 HID1, after: 16080 Calibrating delay loop... 665.19 BogoMIPS Starting kswapd Journalled Block Device driver loaded PCI: Enabling device 00:10.0 (0086 -> 0087) radeonfb: ref_clk=2700, ref_div=12, xclk=20025 from OF radeonfb: detected DFP panel size from EDID: 1280x854 aper_base: b8000000 MC_FB_LOC to: bbffb800, MC_AGP_LOC to: ffffc000 Console: switching to colour frame buffer device 160x53 Registered "ati" backlight controller, level: 15/15 radeonfb: ATI Radeon M9 Lf DDR SGRAM 64 MB radeonfb: DVI port LCD monitor connected radeonfb: CRT port no monitor connected input0: Macintosh mouse button emulation pty: 256 Unix98 ptys configured Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ide0: Found Apple KeyLargo ATA-4 controller, bus ID 2 ide1: Found Apple KeyLargo ATA-3 controller, bus ID 0 Probing IDE interface ide0... hda: TOSHIBA MK6021GAS, ATA DISK drive Probing IDE interface ide1... hdc: MATSHITADVD-R UJ-815, ATAPI CD/DVD-ROM drive ide0 at 0xe82b3000-0xe82b3007,0xe82b3160 on irq 19 ide1 at 0xe82b7000-0xe82b7007,0xe82b7160 on irq 20 hda: Enabling Ultra DMA 4 blk: queue c0275f98, I/O limit 4095Mb (mask 0xffffffff) hda: 117210240 sectors (60012 MB), CHS=116280/16/63, UDMA(66) Partition check: hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 Macintosh non-volatile memory driver v1.0 apm_emu: APM Emulation 0.5 initialized. mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 131072 bind 65536) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Linux IPX 0.47 for NET4.0 IPX Portions Copyright (c) 1995 Caldera, Inc. IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc. adb: starting probe task... EXT3-fs: INFO: recovery required on readonly filesystem. EXT3-fs: write access will be enabled during recovery. adb devices: [2]: 2 c4 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ISO, swapping keys. input1: ADB HID on ID 2:2.c4 input2: ADB HID on ID 7:7.1f ADB mouse at 3, handler set to 4 (trackpad) input3: ADB HID on ID 3:3.01 adb: finished probe task... kjournald starting. Commit interval 5 seconds EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 128k init 8k chrp 8k prep Adding Swap: 1980296k swap-space (priority -1) EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,10), internal journal sungem.c:v0.97 3/20/02 David S. Miller (davem@redhat.com) eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:0a:95:9e:87:ee eth0: Found BCM5421 PHY Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] Yenta IRQ list 0000, PCI irq58 Socket status: 30000006 Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 440M agpgart: Detected Apple UniNorth 1.5 chipset agp: configuring for size idx: 4 agpgart: AGP aperture is 16M @ 0x0 [drm] Initialized radeon 1.8.0 20020828 on minor 0 eth0: switching to forced 100bt drm: ioremap_agp, offset: 0x00000000, size: 0x00101000 ->pt=0xe986a000 drm: ioremap_agp, offset: 0x00101000, size: 0x00001000 ->pt=0xe50c2000 drm: ioremap_agp, offset: 0x00102000, size: 0x00200000 ->pt=0xe996c000 [drm] Loading R200 Microcode eth0: switching to forced 10bt eth0: switching to forced 100bt eth0: switching to forced 10bt eth0: switching to forced 100bt eth0: switching to forced 10bt hermes.c: 5 Apr 2002 David Gibson orinoco.c 0.11b (David Gibson and others) airport.c 0.11b (Benjamin Herrenschmidt ) eth1: Station identity 001f:0001:0008:0046 eth1: Looks like a Lucent/Agere firmware version 8.70 eth1: Ad-hoc demo mode supported eth1: IEEE standard IBSS ad-hoc mode supported eth1: WEP supported, 104-bit key eth1: MAC address 00:30:65:26:1B:EF eth1: Station name "HERMES I" eth1: ready airport: card registered for interface eth1 usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers PCI: Enabling device 10:18.0 (0000 -> 0002) PCI: Enabling bus mastering for device 10:18.0 usb-ohci.c: USB OHCI at membase 0xe50fa000, IRQ 27 usb-ohci.c: usb-10:18.0, Apple Computer Inc. KeyLargo USB usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Enabling device 10:19.0 (0000 -> 0002) PCI: Enabling bus mastering for device 10:19.0 usb-ohci.c: USB OHCI at membase 0xe50fc000, IRQ 28 usb-ohci.c: usb-10:19.0, Apple Computer Inc. KeyLargo USB (#2) usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected hub.c: new USB device 10:19.0-1, assigned address 2 input4: USB HID v10.01 Mouse [Microsoft Microsoft 3-Button Mouse with IntelliEye(TM)] on usb2:2.0